3M APIF100, Инструкция по установке и эксплуатации

Страница: 20 / 36

HOW TO SET TIMER CONTROL
SET
HOUR
Regen
Min. Fill
Regen
Hour
Time - Hour
PM
Days To Regen
Power Loss
If the power goes out, current time of day will need to be reset. If the power goes out while the system is
regenerating, the cycle picks up where it was when the power went out.
Error Message
If “E1” “E2” or “E3” appears on the display, contact 3M Purifi cation Inc.’s Technical Support Services @1-
866-692-2543. These are error codes and will need to be resolved before the control valve will function.
These codes indicate that the control valve did not function properly.
3-11
USER DISPLAYS
General Operation
When the system is operating, one of two displays will be shown. Pressing or button will alternate be-
tween the displays. One of the displays is always the current time of day (to the nearest hour). The second
display is the days remaining until the next regeneration. If the days remaining is equal to one, a regenera-
tion will occur at the next preset regeneration time. The user can scroll between displays as desired.
If the system has called for a regeneration that will occur at the preset time of regeneration, the arrow
will point to Regen.
Regeneration Mode
Typically system is set to regenerate at a time of low water usage. Your Iron Reduction System is factory
preset to regenerate at 1:00 AM. If there is a demand for water during the regeneration period, untreated
water will be used.
When the system begins to regenerate, the display will change to indicate the cycle of the regeneration
process that is occurring and an arrow will also point to
REGEN . The system will run through the steps
automatically and will reset itself to provide treated water when the regeneration is completed.
or
SET
HOUR
Regen
Min. Fill
Regen
Hour
Time - Hour
PM
Days To Regen
SET
HOUR
Regen
Min. Fill
Regen
Hour
Time - Hour
PM
Days To Regen