The CR-10 Pro version also has smaller connectors at the
top and right side when viewed from the front.
The front should look like the picture to the right.
2. Assemble Front Door
Locate the magnetic latches and use the
wood screws
to
attach them to the latch mounts. Hand tighten and make sure
they’re secure, but do not over tighten or they may strip. The
latch can be later adjusted front-to-back to make sure the
door is flush with the door frame.
Each latch mount is attached via three screws. Two M4
10mm cap heads are used to attach the latch mount to the
side, while a 30mm cap head secures the latch mount to
the door frame.
Attach the hinges to the door and door frame using M4
12mm screws and nuts. There will be some play in the hole
size so that you can adjust the door to swing freely.
Copyright 2020 3DUpfitters
7
