7. Sealing Gaps
Once the enclosure is completely put together, it is time to make sure that each of the
panels is held tightly to each adjoining panel. The connectors are designed with a
small amount of play that allows you to make small adjustments for the perfect fit.
1. Loosen screws on the panel to move.
2. Push that panel into place. You may need a friend to hold it tightly in the right spot.
3. Re-tighten the screws to hold the panel.
Repeat the product, going around the enclosure looking to make sure all of the panels
are flush to each other.
8. Filament
Filament is fed into the enclosure from the included spool holder. It should sit on top of
the enclosure on the end approximately where the filament spool would have been
oriented without an enclosure. Of course, if you don’t like this spool holder you are
free to use whatever type of freestanding spool holder you wish; there are hundreds of
designs available on Thingiverse.
Copyright 2020 3DUpfitters
15
