Attach the door knob by first inserting the square M4 nut into
the slot. Use a 16mm cap head screw to attach the door.
Now that the latches are mounted it is time to connect the
strike plates. Each plate comes with a squishy adhesive
covering the same size of the plate. Carefully attach the
adhesive side to the acrylic at the location of each latch.
Then, adjust the width of the metal strike plate so that it is
held on by the pressure of the two sides of the plate. The
adhesive covering will keep the metal strike plate from
scratching the acrylic.
3. Attach Left Side
Attach the left side to the front forming an L-shape that
will stand up on its own, then attach one L and one R
connector at the back.
The CR-10 Pro design adds a side door for easy
access to the extruder, the parts for which are shipped
in a separate packet.
The latch mounts are smaller than the front, although
the magnetic latch attaches in the same way with wood
screws. The parts for the side door will be in a separate
packet.
Attach the door hinges, latch mounts, strike plates, and
the knob, and the assembly will look like the illustration
to the right. Don’t forget the mid-panel connectors at
the back left and top.
Copyright 2020 3DUpfitters
8
