3DLabPrint Hawker Sea-Fury FB 11, Инструкция по сборке и эксплуатации

Страница: 6 / 37

T
3D Printed project by ADDIMP 3D
- 2x Rubber band 120 x 10 mm or 1x M6 nylon screw and nut (wing fixation)
- Wire pushrod Ø1mm
- hinge sheet, thickness 0.3mm
- Ø2mm rod hard wood or carbon for the rudder hinges
- CA medium
- 1x Velcro strap 200 mm
- 2x servo extension cable for aileron, length 150 mm minimum.
- Option ; 1 carbon tube Ø4 mm x 380 / 500 mm
- Landing gear :
o
2x Ø45 / 50 mm wheel for main gear, or print the one included
o
1x Ø20mm for tailwheel
All accessories could be found at http://www.rcjetshobby.com/en/10000493-sets-addimp-3d
Pro-tronik motors : http://www.rcjetshobby.com/en/10000450-pro-tronik
Pro-tronik ESC : http://www.rcjetshobby.com/en/81-controleurs
6- Print settings
!! the use of the LW-PLA from Colorfab is explain in a specific file in the factory directory !!
Few quantity of parts needs special parameters, they are describe when needed.
G-Codes are based on Prusa Mk3 & Mk 3S, Ø1.75mm PLA.
The use with other 3D printer or filament will have different results. Even in the same brand of filament,
color may change results.
As often as possible use the factory files to adapt to your 3D printer and your filament.
Example of possible parameters :
Nozzle diameter = 0.4 mm
General layer thickness = 0.25 mm
Extrusion width = 0.42 mm
Default printing speed = 60 mm/s
1st layer thickness = 80% or 0.2 mm
1st layer width = 105 to 110%
1st layer speed = 50 to 66%
Retraction distance, depend of the filament, ~ 1 to 2 mm, to be adjust
Retraction speed = 30 mm/s