3DLabPrint Hawker Sea-Fury FB 11, Инструкция по сборке и эксплуатации

Страница: 11 / 37

T
3D Printed project by ADDIMP 3D
There is a specific support to remove on W3, it is used to maintain the trailing edge during printing process.
Assemble all the parts without any glue, to check the well adjustment and alignement.
If you use the carbon tube option, check that it slides freely in its housing.
Then glue each section together, beginning by root section, L1 with L2, then L3.
Same order for the right wing.
Assemble the three parts of the aileron (int / mid / ext).
There are two hinges by aileron. They must be cut in a 20 x 25 mm rectangle, then adjusted in place.
then assemble aileron with hinges and with wing before assemble the full wing.
Be careful not to twist the wingtip during the entire bonding process. You can use Ø2 rods to join the 2
wings together.
Don’t forget the Ø4mm carbon tube if you intend to use it.
W3L
W2L
W1L
Right Aileron Ext / mid / Int
LE cannons LE smooth