3DLabPrint Hawker Sea-Fury FB 11, Инструкция по сборке и эксплуатации

Страница: 18 / 37

T
3D Printed project by ADDIMP 3D
9.1- Motor mount
The motor is installed with a specific support. It is installed from the front.
The support is fixed by 3 M3 x 18 self-locking nuts in the aircraft structure.
There are several versions of motor supports corresponding to the main dimensions of the trade.
If you wish to use another engine, do not hesitate to ask us for a special support specifying the dimensions
of your engine.
Install 2 of the M3 nuts in the housings in F1, the last is on the motor mount.
Use a needle nose pliers to facilitate the placement of the nuts. A point of CA glue allows to fix the nut in
place.
Also install the strap for the battery. The openings come out of print.
Cut along the contour for the passage of the servo (s), then install the servo (s); elevator at « EL », rudder at
« RU ».