3D Systems Fiure 4 Standalone, Руководство пользователя, Страница: 32 / 120

8/12/22, 2:53 PM Руководство пользователя
ru.infocenter.3dsystems.com/figure4jewelry/print/book/export/html/526 32/120
ПРИМЕЧАНИЕ . Осмотрите напечатанные детали после обработки в LC-3DPrint Box, чтобы убедиться в их полном
отверждении . Вязкость поверхности и видимые области жидкого материала означают , что деталь недостаточно отверждена .
« Сырые » напечатанные детали с неотвержденным материалом на них .
Указания по эксплуатации и хранению
Please see the section Material Handling and Safety for more information. Always read the material's Safety Data Sheet (SDS) prior to use of
any Figure 4 material.
Figure 4 Jewelry Advance Preparation Checklist
NOTE: Unless governed by prior arrangement, 3D Systems is not responsible for loading 3D Sprint software on the user’s
workstation(s). Thus, BEFORE THE 3D PRINTER SYSTEM ARRIVES, ensure that your workstation is capable of supporting the
requirements of both 3D Sprint software and communication with the printer via your network.
Checklist
Review this list with a network administrator, IT department, facilities manager, and/or other responsible person within your organization. Please
complete the following information:
This is NOT an online form and CANNOT be submitted on this webpage. The form must be printed out and faxed/emailed.
Название компании :
Telephone (with area code):
Contact (print full name):
Date faxed:
Адрес электронной почты :
Поставьте отметку напротив каждого выполненного пункта .
Operating system and workstation con gurations are compatible and meet the minimum requirements as stated in the 3D Sprint Software section.
Final installation site is selected. The intended physical location for the printer should be selected in advance, and checked for adherence to the
guidelines set out in this guide .
Flooring where printer will be located is non-porous , has an incline of less than/equal to 2.5 cm/12 m (1 in/40 ft), and is isolated from signi cant
sources of vibration.
Flooring can take the
total weight of all system components combined in the room(s) they are in.
Enough surge-protected circuits have been installed to accommodate the number of printers, and other products, ordered. Enough power outlets
have been installed on these circuits.
If desired/required, you have purchased enough uninterrupted power supplies (UPS) for the number of printers, and other products, ordered.
You have a print-material-storage area set up that can be kept at 5°C-30°C (41°F-86°F) . Temperature of 3D-printing room can be kept at 18-28°C
(64.4-82.4°F).
3D-Printing room can be kept between 30-70% relative humidity (RH).
3D-Printing room is less than 2,400 m (1.5 mi) above mean sea level.
HVAC can perform at least six air changes per hour and 3D-Printing room is well-ventilated and has clean air.
3D-printing room lighting is either uorescent lamps with clear-plastic diffusers, or has su cient UV lters covering its lights.
Both the 3D-printing room and material-storage area can be isolated in the event of a resin spill or open-radiation Service call.