3Com VCX V7000, Руководство по установке

Страница: 303 / 488

Attendant Console Installation 303
vcxReset
The Attendant Console communicates with the Primary VCX Server. Use
the Administrator Interface to:
■
Verify that the Attendant Console has been discovered by the VCX
system
■
Perform the remaining configuration of the Attendant Console
■
Associate the Attendant Console with a particular phone
For instructions on how to perform these tasks, see the VCX
Administration Guide.
Manually Configuring
the 3105B Attendant
Console
To manually configure your 3Com 3105B Attendant Console:
1 Plug a standard Ethernet cable into the data port, located on the
underside of the console.
2 Plug the other end of the Ethernet cable into an active network jack.
3 Using an RJ45 to DB9 adapter cable (see Table 13 , earlier in this chapter
for the pin assignments) and a standard Ethernet cable, connect a serial
port on your PC to the serial port on the underside of the 3105 Attendant
Console.
4 Connect a 3Com power adapter to an AC power outlet.
5 Connect the other end of the power adapter cable to the power
connector on the underside of the 3105 Attendant Console.
6 Use a terminal emulation program such as Hyperterm to connect to the
serial port on your PC. The configuration is:
■
9600 baud
■
8 data bits
■
1 stop bit
■
No parity
■
No flow control
7 In the Hyperterm window, enter this command to set the IP address of
the Primary VCX Server:
nbxSetNcpIpAddress “10.20.30.41”