3Com TokenLink 3C339, Руководство пользователя

Страница: 35 / 78

Installing NetWare Drivers 3-11
Installation with NetWare 3.12 and 4.x
To install the NetWare server driver for NetWare while
running NetWare 3.12 or 4.x, follow these steps:
1 Determine the NIC port addresses, as described in
“Finding the NIC’s Port Address” earlier in this
chapter.
2 Before starting the server, copy the contents of the
appropriate directory on TokenDisk diskette #1 to
the boot partition of the server’s hard disk:
■
For NetWare 3.12, use the \NETWARE\SERVER\3.12
directory
■
For NetWare 4.x, use the \NETWARE\SERVER\4.X
directory
3 Start the server and enter the following commands
at the server prompt:
load C:3C3X9.LAN PORT=XXXX NAME=X
load C:3C3X9.LAN PORT=XXXX NAME=Y
where XXXX is a NIC port address and X and Y are
names that you assign to help distinguish the
multiple NICs.
The PORT=XXXX parameter must be completed for
all NICs.
4 Bind the appropriate transport protocol to each
NIC name.
Add the load and bind commands to the AUTOEXEC.NCF
file for automatic execution when you start or restart
the server.
This concludes the procedure for installing the NetWare
server driver for multiple NICs in a server with
NetWare 3.12 or 4.x.
Book Page 11 Thursday, June 5, 1997 9:07 AM