Accessing the Wizard
39
Bridging Mode
Figure 20
Bridging Mode Screen
To set up the Firewall Router for use as a bridge in which the router is
the bridge between WAN and LAN, use the following procedure:
1
Enter the name for the bridging service.
2
Enter the IP Address and Subnet Mask for the LAN. See
“LAN
Settings”
LAN Settings
Figure 21
LAN IP Address Screen
This screen displays a suggested LAN IP address and subnet mask of
the Firewall Router. It also allows you to change the IP address and
subnet mask.
1
Primary IP Address: Enter the first IP Address for your LAN interface.
2
Subnet Mask: Enter the Subnet Mask for your LAN interface.
3
Enable DHCP server on the LAN: Check this box to enable the DHCP
service on the router. See
“DHCP”
in this section.
Содержание OfficeConnect 3CRWDR200A-75
