3Com OfficeConnect 3C100XF, Руководство пользователя CLI

Страница: 64 / 260

6-2 C
HAPTER
6: B
RIDGING
C
OMMANDS
Bridging Commands The following table identifies the Bridging commands accessible from the
OfficeConnect Gateway CLI:
Remember to save your configuration using the save all command before
rebooting your OfficeConnect Gateway so that your changes will be written to
permanent FLASH memory.
Configure Bridging for
the LAN and WAN
To configure a protocol over the LAN, you need to assign a protocol network to
the LAN port by providing it with a name. After adding a network, you can modify
the advanced parameters.
Use the following CLI commands to configure bridging for the LAN and WAN:
add bridge network
<network name>
Use the add bridge network <network name> command to add a bridge
network over the Ethernet interface.
list networks
Use the list networks command to obtain a list of all configured networks.
list bridge networks
Use the list bridge networks command to only list bridge networks.
Command
Type Command Name
Add add bridge network < network name >
Delete delete bridge network < network name >
Enable enable bridge spanning_tree
Disable disable bridge network < network name >
disable ip forwarding
disable bridge spanning_tree
List list bridge networks
list bridge forwarding
Set set bridge aging_time <seconds>
set bridge forward_delay <seconds>
set bridge spanning_tree_priority <priority value>
set bridge firewall discard_routed protocols
set bridge firewall fwd_unicast_only
set bridge firewall fwd_bc_and_unicast
Show show ip settings
show bridge settings
show bridge network <name>