12
P
OSITIONING
THE
N
ETWORK
S
TORAGE
S
ERVER
Choosing a Suitable Site
When you install your Network Storage Server, ensure:
■
It is out of direct sunlight and away from sources of heat.
■
Cabling is away from power lines, fluorescent lighting fixtures,
and sources of electrical noise such as radios, transmitters and
broadband amplifiers.
■
Water or moisture cannot enter the case of the unit.
■
Air flow around the unit and through the vents on the side of
the case is not restricted. 3Com recommend you provide a
minimum of 25 mm (1 in.) clearance.
■
Cabling is secure and not pulled taut.
CAUTION:
Do not wall-mount the Network Storage Server and
do not wall-mount stacked units.
CAUTION:
The Network Storage Server is not a portable device
and is sensitive to mechanical shock. Do not subject it to
vibration, unnecessary transit or movement.
Stacking the Network Storage Server
Fitting the Rubber Feet
The four self-adhesive rubber feet prevent your Network Storage
Server from moving around on your desk. Only stick the feet to
the marked areas at each corner of the underside of your
Network Storage Server if you intend to place the unit directly on
top of the desk.
Fitting the Stacking Clip
The blue stacking clip allows you to stack your Network Storage
Server with other OfficeConnect Units neatly and securely.
CAUTION:
You can stack up to a maximum of four
OfficeConnect units. Smaller units must be stacked above larger
units.
You must place the Network Storage Server at the bottom of the
stack.
To fit the Stacking Clip:
1
Place your unit on a flat surface.
2
Position the clip across the top of the unit, as shown in
Figure 2
(picture 1), ensuring that the longer sections of the fastening
pieces are pointing downwards.
3
Align the fastening pieces over the slots found on each side of
the unit.
4
Push the clip down gently to secure it, ensuring the fastening
pieces snap into the slots on the unit.
