Removing NIC Software
85
Removing NIC Software
EtherDisk
diskette 2
includes an uninstallation program
to remove the 3C509B NIC software.
To run the uninstallation program, at the DOS
prompt, enter:
un3c509.exe
The NIC software is removed from your PC.
Configuring the NIC
This section describes how to configure the 3C509B NIC
after you install it in your PC. If only one 3C509B NIC
is installed and you are running Novell NetWare, use
the Intelligent Auto Install program to configure the
NIC and load the appropriate driver, as described earlier
in this chapter.
To configure the 3C509B NIC, follow these steps:
1 Install the NIC (see
Chapter 1
) and the network driver
(earlier in this chapter).
2 Reboot to DOS.
3 Insert
EtherDisk
diskette 2 in drive A.
4 Run the installation program. Enter:
a:install
The main menu is displayed, as shown in
Figure 58
on
page 82
.
The 3Com software license agreement is displayed the first
time you run the DOS installation program. Type
Y
to accept
the agreement and display the main menu.
5 Select
Configuration and Diagnostic Program
.
If you have more than one NIC installed in the PC, select
the NIC you want to configure. Tab to the
Select
button
and press Enter.
Book Page 85 Monday, June 7, 1999 8:55 AM
