43
LECS Address Section
This section prompts you for the ATM address of the LECS. Enter the
appropriate values. If you changed the network prefix in the previous
section (Network Prefix), you must also change the network prefix in this
section. The following example shows a typical LECS Address:
UNI/NNI Parameters Section
This section prompts you for the UNI/NNI/GWY configuration of the ports
on the ATM Interface Module and includes all ports on all installed
daughter cards.
To enter the UNI/NNI Configuration:
1
At the NNI max hops prompt, enter the maximum number of hops
(0-120).
2
At the Enter port ID prompt, enter or accept the Port ID for each port
(1-4), including the slot number (1-7, 10,12,14,16), the group number (1
or 2) and the port number (1-4).
3
At the NNI type of port prompt, enter or accept the NNI type for the port
you just specified. The port can be UNI (enter U), NNI (enter N), or
Gateway (enter G).
4
Repeat steps 2 and 3 until you have specified the NNI type for all of the
ports that are in the Corebuilder 9000 Enterprise Switch chassis. When
you are finished enter 0.
5
The LMA automatically prompts you for the NNI type of the ports that
you have specified as Gateway. Specify the NNI type as User or Network
*** The following is a profile of ports you have defined as
Gateway: Profile of port <1.1.1>(U<ser>,N<etwork>):
6
Repeat until you have specified all of the Gateway ports.
LECS Address
------------
Active LECS Net Prefix (In HEX): 47.00.00.00.00.00.3c.00.00.a*
Active LECS user part (In HEX): 00.a0.3e.00.00.01.00
