Copyright ©2019 by 3Built LLC
9/30/19
Firmware ver:6.1.19
PROGRAMMING
NORMALLY-OPEN MODE. (Image #2)
This step must be performed if connecting as normally open.
When the
Receiver
is powered on, the relay is in a closed state (normally-closed) by default. Some ignition systems like the MSD Pro
Mag 12 need a normally-open relay operation. This method allows you to change the operation of the
Receiver
so that when the
Receiver
is powered on, the relay is in an open state and does not allow electricity to flow.
1)
Turn
Receiver
off and then back on to determine its current state. Check the
Receiver
LEDs immediately after power up.
a.
The yellow LED will illuminate and the Red LED will flash to indicate normally-closed mode.
b.
The yellow LED will illuminate and the Green LED will flash to indicate normally-open mode.
2)
Turn
Receiver
and
Transmitter
off.
3)
Turn
Receiver
ON and make sure the green or red LED is on to show Run or Off mode. Proceed to steps #3 & #4 within 30
seconds.
4)
Press and hold the RED button on the
Transmitter
.
5)
Turn the
Transmitter
ON via the toggle switch.
6)
Continue to hold the RED
Transmitter
button for at least 15 seconds.
7)
The
Receiver’s
LEDs will blink to indicate mode change.
8)
Release the red button on the
Transmitter
9)
Perform Step #1 in this section to confirm desired mode.
STATUS CHECK MODIFICATION
Transmitter asks the receiver if it is in off or run mode every 30 seconds. This can be disabled, if desired.
1)
Turn
Receiver
and
Transmitter
off.
2)
Press and hold the green button on the
Receiver
.
3)
Turn the
Transmitter
on via the toggle switch.
4)
Continue to hold the green button for at least 10 seconds.
5)
The
Transmitter’s
LEDs will blink:
a.
If the green LED blinks, the
Receiver
is in Status Check Every 30 Seconds mode.
b.
If the red LED blinks, the
Receiver
will not check status every 30 seconds.
ADDITIONAL FEATURES
The
Transmitter
queries the
Receiver
on power-up, during every button press, and every 30 seconds. 30-second check is
optional; see Programming section.
The
Transmitter
will automatically power off after 6 hours of inactivity to conserve the battery. Turn off and on again to
reset.
Press the Green button to check range status without shutting off the vehicle
These instructions are subject to change without notice.
Limited Liability Company: West Hills, CA
www.3Built.com
Technical Support:
