360 BANDIT KINZE 3000, Руководство по установке

Страница: 2 / 6

INSTALLATION INSTRUCTIONS
KINZE 3000
Using a 9/16” socket, remove the bolt that holds the closing
wheel arm stop
5
to the row unit between the gauge
wheels.
NOTE: The gauge wheels may need to be held up to remove
the bolt.
Using a 3/4” socket remove the nut from the carriage bolt
that secures the closing system arms on the row unit.
Remove carriage bolt and remove closing system arms
6
from the row unit. Discard carriage bolt, nut and washers.
Retain two piece bushing
7
.
Remove spring from closing wheel arm stop and set closing
wheel arm stop to the side.
NOTE: Retain closing wheel arm stop in a safe location for
installation of closing system without 360 BANDIT.
Hammer/Mallet
Wrench Sizes: 3/4”, 9/16” and 15/16”
Socket Sizes: 3/4”, 9/16” and 15/16”
Impact Driver/ Socket Wrench
Release spring
1
to remove tension from closing system.
Remove closing wheels with a 15/16” socket and wrench
2
.
Retain the closing wheels, bolts, and nuts for re-installation
later in the instructions.
If present, remove insecticide attachment.
NOTES:
Removal of the closing wheels is necessary to facilitate the
ease of removing and reinstalling the spring.
If you are installing the optional chains kit, the bolts and
nuts
3
can be discarded but the bushings
4
need to be
kept.
1
2
3
4
5
6
7
BEFORE YOU BEGIN...
HELPFUL TOOLS
STEP 1
REMOVE CLOSING WHEELS
STEP 2
REMOVE CLOSING SYSTEM ARMS
PAGE 2