2N Analog Vario, Руководство по установке

Страница: 22 / 77

Installation manual 2N® Analog Vario
22 / 77
9.
10.
11.
12.
13.
14.
Connect the cables as described in subsection 2.4, Mounting – Electrical Installation. Make
sure that the cables are not squeezed while installing the plastic cover. For the correct
cable installation.
Remove the protective foil from the display (for display-equipped 2N
®
Analog
Vario versions only).
Make sure that the cables are placed properly inside and that none of them obstructs a
perfect cover closure.
Make sure that the three loudspeaker holder feet fit into the board holes. Keep the
required loudspeaker position to make the seal work properly.
Having mounted the unit on the wall and connected all cables, replace the plastic cover
using cross-recessed screws.
Take out the name plates from the plastic cover. Use a flat-bladed screwdriver, for
example.
•
Warning
Remember to tighten all the four corner screws to fix the loudspeaker seal
after electric installation to avoid water in-leak! A
PZ1 cross-head
screwdriver is recommended.
