2N 02407-001, Руководство по установке

Страница: 33 / 88

Installation Manual 2N® IP Style
33 / 88
It is assumed that the chassis ( 2.2.1 Chassis Installation ) or the flush mounting box ( 2.2.2
Mounting Box Installation ) and all of the required cables have been installed. The recommended
length of the accessible cables is 35 cm.
Unscrew the connector cover on the back of the device. Thread all of the unterminated cables
(i.e. without terminals, end pieces, etc.) through the bushing on the inside of the connector
cover. After threading the cables through the bushing, fit the required end pieces (1).
Fold out the mounting bracket located at the bottom of the chassis or flush mounting box. Fit
the profiles on the device back onto the mounting bracket and slide them down to the lowest
possible position, anchoring the device by snapping it into place (2A).
Connect all the cables to the device (2B). The mounting bracket provides sufficient support for
cable installation and so it is unnecessary to support the device in any way.
After connecting and securing the superfluous cabling in the clips (3A), screw the connector
cover back on (3B), fold in the device towards the chassis or the flush mounting box (4A) and
then press downwards (4B) to seal the installation.
Now all you have to do is lock the position by tightening the two screws inside the device using
an Allen key (5).
General Mounting Principles
•
•
Tip
Select flush mounting where possible. This makes the product elegant looking,
more vandal resistant and more secure.
You are advised to purchase the flush mounting boxes and chassis in advance and
commission a building company to do the masonry for you, for example.
