247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
14
2.2.9.
G-FORCE CONNECTOR
This connector is used to plug in the included event marker cable.
Pin Number
Signal Description
Pin out
1
RS485 T(-)
2
RS485 T(+)
3
RS485 R(+)
4
RS485 R(-)
5
GND
6
+5VDC OUT
2.3.
CABLE REQUIREMENTS
2.3.1.
POWER CABLE
A 15 ft three wire power cable is included for connection between the DVR and your vehicle power and ignition
signals. It is highly recommended that in-line fast blow fuses (7.5 - 10 amps) be installed on the two power input
connections for safety pre-cautions.
Wire Color
Signal
Description
Picture
Red
VIN
Input voltage (8~24VDC)
Black
GND
Ground
White
ON/OFF
Ignition switched power
(only hot when ignition is
in RUN/ACC
2.3.2.
EVENT MARKER CABLE
A 15 ft cable is already connected to the Event Marker and pre-wired to a 2X3 Molex connector; the Molex
connector will then connect to the event marker port on the back of the DVR. The event marker uses 3 digital
outputs for Video Lost, Recording & Power LED’s and 1 digital input for the push button. The push button is used
for pre/post trigger recording which when pressed, marks the video files at that specific moment. Pre-event and
Post-event time locking can be configured in the DVR setup.
Connector
Signal
Description
Picture
6-Pin
Molex
Connects to Event Marker
connector on DVR
