P. 72
nanobox | tangerine User Manual
Dec 11, 2023
Editing the Sample Start and Length in the Waveform Screen
1.
Open the Waveform screen from the pad’s Macro screen by pressing Right Arrow.
2.
Play the pad over MIDI or by touching the play button at the top of the screen.
3.
Check the Pad Grid in the top left of the screen to verify you are editing the
correct pad. If necessary, step through the pads with the Layer button until you
reach the correct pad.
4.
Touch the Play button at the top of the screen to hear the sample. Notice the
playback point moves across the waveform when you play it.
5.
Rotate the tangerine’s top knob until the Length parameter appears in the
bottom right part of the screen. If the top knob does not seem to do anything,
press Left Arrow to return to the pad’s Macro screen and make sure the pad is in
Sample Pad Mode.
6.
Adjust the sample length with the bottom knob until the sample end point is
where you want it.
7.
Listen to how the sample changes while you adjust the sample’s length.
8.
Use traditional swipe, pinch, and spread gestures on the touch screen to zoom in
on the part of the waveform where you want to move the sample Start position.
9.
Select the Start parameter by turning the top knob until Start appears at the
bottom of the screen.
10.
Move the Start point with the bottom knob. Note that the sample end point shifts
when you move the Start point. Listen to how the sample changes while you
adjust the sample’s start point and length.
Note:
■ The Waveform screen hides the Start and Length parameters if the
Pad Mode is Clip or Slicer Pad Mode.
