Prestige 100MH PSTN Router/Hub
10-15
Chapter 10
System Maintenance
10.7.2 Uploading ROM File
Menu 24.7.2 shows you the instructions for uploading ROM file. Uploading the ROM file
replaces the entire ROM file system, which includes the
Prestige
’s configuration,
system-related data, the error log and the trace log. If you answer yes to the prompt, the
Prestige
will reboot automatically. Press any key when you see the message “Press Any key to
enter Debug Mode within 3 seconds.” to enter debug mode.
Once in debug mode, type [
atur
3
] and wait for your
Prestige
to respond with “Starting
XMODEM upload” to begin uploading the ROM file. (upload procedure varies depending on
the software used to access your
Prestige
). After successfully uploading the ROM file, type
[
atgo
]
to restart your
Prestige
.
If you upload the default ROM file, you will lose all configurations that you had before and
the RS-232 port will be set to the default of 9600 baud. You will need to change the baud rate
of your serial communications software to 9600 before you can connect to the
Prestige
again.
Figure 10-12. Menu 24.7.2 - System Maintenance - Upload ROM File
Menu 24.7.2 -- System Maintenance - Upload ROM File
To load the ROM file, type "atur3" while in debug mode and wait for
"Starting XMODEM upload" before beginning to upload file. Type
"atgo" after file has successfully loaded to start RAS. Then change
the baud rate to 9600.
Proceeding with the upload will erase the current ROM file.
Do You Which To Proceed:(Y/N)