Chapter 36 Access Control
XS1930 Series User’s Guide
297
The following table describes the labels in this screen.
36.3.3 Configuring SNMP User
From the
SNMP
screen, click
User
to view the screen as shown. Use the
User
screen to create SNMP users
for authentication with managers using SNMP v3 and associate them to SNMP groups. An SNMP user is
an SNMP manager.
Figure 217
Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Table 154 Management > Access Control > SNMP > Trap Group > Port
LABEL
DESCRIPTION
Option
Select the trap type you want to configure here.
Port
This field displays a port number.
*
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active
Select this check box to enable the trap type of SNMP traps on this port.
Clear this check box to disable the sending of SNMP traps on this port.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 155 Management > Access Control > SNMP > User
LABEL
DESCRIPTION
User Information
Note: Use the username and password of the login accounts you specify in this
screen to create accounts on the SNMP v3 manager.
Username
Specify the username of a login account on the Switch.
