Chapter 31 Link Layer Discovery Protocol (LLDP)
XS1930 Series User’s Guide
249
31.6 LLDP Configuration
Use this screen to configure global LLDP settings on the Switch. Click
Advanced Application
>
LLDP >
LLDP Configuration (Click Here)
to display the screen as shown next.
Figure 176
Advanced Application > LLDP > LLDP Configuration
The following table describes the labels in this screen.
Table 124 Advanced Application > LLDP > LLDP Configuration
LABEL
DESCRIPTION
Active
Select to enable LLDP on the Switch. It is enabled by default.
Transmit Interval
Enter how many seconds the Switch waits before sending LLDP packets.
Transmit Hold
Enter the time-to-live (TTL) multiplier of LLDP frames. The device information on the
neighboring devices ages out and is discarded when its corresponding TTL expires. The TTL
value is to multiply the TTL multiplier by the LLDP packets transmitting interval.
Transmit Delay
Enter the delay (in seconds) between successive LLDPDU transmissions initiated by value or
status changes in the Switch MIB.
Reinitialize Delay
Enter the number of seconds for LLDP to wait before initializing on a port.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Port
This displays the Switch’s port number. * means all ports.
