Chapter 6 Broadband
PX7511-B0 User’s Guide
84
The following table describes the fields in this screen.
6.3 Technical Reference
The following section contains additional technical information about the Zyxel Device features
described in this chapter.
Encapsulation
Be sure to use the encapsulation method required by your ISP. The Zyxel Device can work in bridge
mode or routing mode. When the Zyxel Device is in routing mode, it supports the following methods.
IP over Ethernet
IP over Ethernet (IPoE) is an alternative to PPPoE. IP packets are being delivered across an Ethernet
network, without using PPP encapsulation. They are routed between the Ethernet interface and the
WAN interface and then formatted so that they can be understood in a bridged environment. For
instance, it encapsulates routed Ethernet frames into bridged Ethernet cells.
PPP over Ethernet (PPPoE)
Point-to-Point Protocol over Ethernet (PPPoE) provides access control and billing functionality in a
manner similar to dial-up services using PPP. PPPoE is an IETF standard (RFC 2516) specifying how a
personal computer (PC) interacts with a broadband modem (DSL, cable, wireless, etc.) connection.
For the service provider, PPPoE offers an access and authentication method that works with existing
access control systems (for example RADIUS).
Table 18 Network Setting > Broadband > Add/Edit New WAN Interface (Bridge Mode)
LABEL
DESCRIPTION
General
Click this switch to enable or disable the interface. When the switch goes to the right
, the
function is enabled. Otherwise, it is not.
Name
Enter a service name of the connection.
Type
This field shows
GPON
and indicates a broadband connection to a PON (Passive Optical Network).
Mode
Select
Bridge
when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP’s DHCP server directly. If you select
Bridge
, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN
Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the right
, the function is enabled. Otherwise, it is not.
802.1p
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Cancel
Click
Cancel
to exit this screen without saving.
Apply
Click
Apply
to save your changes.
Summary of Contents for PX7511-B0
