ZyXEL Communications PRESTIGE 650H -, User Manual

Page: 186 / 368

Prestige 650 Series User’s Guide
18-6 Internet Access
Table 18-2 Menu 4 Internet Access Setup
FIELD DESCRIPTION EXAMPLE
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing
used by your ISP. Choices are VC-based or LLC-based .
LLC-based
VPI # Enter the Virtual Path Identifier (VPI) assigned to you. 8
VCI # Enter the Virtual Channel Identifier (VCI) assigned to you. 35
ATM QoS Type Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail. Select
VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
UBR
Peak Cell Rate
(PCR)
This is the maximum rate at which the sender can send cells.
Type the PCR. 0
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR. 0
Maximum Burst Size
(MBS)= 0
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535. 0
My Login Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that your
ISP gives you. If you are using PPPoE
encapsulation , then this
field must be of the form user@domain where domain
identifies your PPPoE service name.
N/A
My Password Enter the password associated with the login name above. N/A
ENET ENCAP
Gateway Enter the gateway IP address supplied by your ISP when you
are using
ENET ENCAP encapsulation.
N/A
Idle Timeout This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session. 0
IP Address
Assignment
Press [
SPACE BAR
] to select Static or Dynamic address
assignment.
Dynamic
IP Address Enter the IP address supplied by your ISP if applicable. N/A