ZyXEL Communications Prestige 650H-17, User Manual, Page: 72 / 200

Prestige 650H-17 ADSL Router
4-6 Remote Node Configuration
4.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors’ implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
4.2 Remote Node Setup
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [ SPACE BAR ] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Figure 4-3 Remote Node Network Layer Options
The next table explains fields in Menu 11.3
–
Remote Node Network Layer Options .
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Dynamic Ethernet Addr Timeout (min)= N/A
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= None
Multicast= None
IP Policies=
Press ENTER to Confirm or ESC to Cancel: