ZyXEL Communications Prestige 650H-17, User Manual, Page: 151 / 200

Prestige 650H-17 ADSL Router
Firmware and Configuration File Maintenance 11-5
where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the
Prestige IP address, “get” transfers the file source on the Prestige (rom-0 name of the configuration file on
the Prestige) to the file destination on the computer and renames it config.rom.
The following table describes some of the fields that you may see in third party TFTP clients.
Table 11-3 General Commands for Third Party TFTP Clients
COMMAND DESCRIPTION
Host Enter the IP address of the Prestige. 192.168.1.1 is the
Prestige’s default IP address when shipped.
Send/Fetch Use “Send” to upload the file to the Prestige and “Fetch”
to back up the file on your computer.
Local File Enter the path and name of the firmware file (*.bin
extension) or configuration file (*.rom extension) on your
computer.
Remote File This is the filename on the Prestige. The filename for the
firmware is “ras” and for the configuration file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
TFTP over WAN will not work if you have applied a filter in menu 11.5 (WAN) to block Telnet service.
11.3 Restore Configuration
Menu 24.6 - System Maintenance - Restore Configuration allows you to restore the configuration via
FTP or TFTP to your Prestige. The preferred method is FTP. Note that this function erases the current
configuration before restoring the previous backup configuration; please do not attempt to restore unless
you have a backup configuration stored on disk. To restore configuration using FTP or TFTP is the same as
uploading the configuration file, please refer to the following sections on FTP and TFTP file transfer for
more details. The Prestige restarts automatically after the file transfer is complete.