ZyXEL Communications P-660RU-T1 v3, User Manual, Page: 75 / 230

Chapter 8 LAN Setup
P-660RU-Tx v3 User’s Guide
75
Figure 28 Interface Setup > LAN
The following table describes the fields in this screen.
Table 17 Interface Setup > LAN
LABEL DESCRIPTION
Router Local IP
IP Address Enter the LAN IP address you want to assign to your ZyXEL Device in dotted
decimal notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your ZyXEL Device automatically computes the
subnet mask based on the IP Address you enter, so do not change this field
unless you are instructed to do so.
Dynamic Route RIP (Routing Information Protocol) allows a router to exchange routing
information with other routers.
Select the RIP version from
RIP1 , RIP2-B and RIP2-M .
Direction Use this field to control how much routing information the ZyXEL Device sends
and receives on the subnet.
Select the RIP direction from
None , Both , IN Only and OUT Only .
Multicast Multicast packets are sent to a group of computers on the LAN and are an
alternative to unicast packets (packets sent to one computer) and broadcast
packets (packets sent to every computer).
IGMP is a network-layer protocol used to establish membership in a multicast
group. The ZyXEL Device supports IGMP v1 , IGMP v2 and IGMP v3 . Select
Disabled to turn off the feature.
DHCP
DHCP If set to Enabled , your ZyXEL Device can assign IP addresses, an IP default
gateway and DNS servers to operating systems that support the DHCP client.
If set to
Disabled , the DHCP server will be disabled.
If set to Relay , the ZyXEL Device acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the clients.
DHCP Server
Starting IP Address This field specifies the first of the contiguous addresses in the IP address pool.