Appendix A Passive Optical Networks
IAD User’s Guide
240
OLT
An Optical Line Terminal (OLT) is placed at a broadband service provider’s central
office, where it receives voice, video, and other data from the service provider’s
networking servers. It then converts and transmits this data as light across a fiber
optical network, where it is received and translated on the opposite end by one or
more Optical Network Units (ONUs).
FTTx
Fiber-To-The-x (FTTx) refers to networking infrastructure that extends from a
service provider to the x, where x can be one of many locations: Office (FTTO),
Home (FTTH), Desk (FTTD), Building (FTTB) or even Curb (FTTC), to name a few.
In an FTTO connection, the Optical Network Unit (ONU) is often placed inside the
building, whereas in FTTH or FTTC the fiber ends at an end-user’s house (or
somewhere nearby), or at a curb-side unit.
Gigabit Ethernet
Gigabit Ethernet (IEEE 802.3z standard) uses Ethernet over copper wire
technology to increase network data rates to 1 Gbit/sec. It is built upon standard
4-pair Category 5 copper cabling.
GEM
The Generic Encapsulation Method (GEM) provides a method for PON devices to
natively transmit both Ethernet and TDM data over optical fiber.
ATM
Asynchronous Transfer Method (ATM) is a LAN and WAN networking technology
that provides high-speed data transfer. ATM uses fixed-size packets of information
called cells. With ATM, a high QoS (Quality of Service) can be guaranteed.
TDM
In Time Division Multiplexing (TDM), individual data subchannels can occupy the
entire frequency bandwidth of a communication stream at certain specific times,
and cannot transmit at other times. Each subchannel takes turns using the
communications stream. TDM is typically used in FTTx and satellite
communication.
Summary of Contents for P-3202HN-Ba
