ZyXEL Communications ONU-2024 Series, User Manual

Page: 205 / 268

Chapter 27 Access Control
ONU User’s Guide
205
27.3.4 Configuring SNMP
From the Access Control screen, display the SNMP screen. You can click Access Control to
go back to the Access Control screen.
Figure 113 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 81 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the ONU. The SNMP version on the ONU must
match the version on the SNMP manager. Choose SNMP version 2c (
v2c ), SNMP
version 3 ( v3 ) or both ( v3v2c ).
Note: SNMP version 2c is backwards compatible with SNMP
version 1.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The
Get Community string is only used by SNMP managers using SNMP version
2c or lower.
Set Community Enter the Set Community , which is the password for incoming Set- requests from
the management station.
The
Set Community string is only used by SNMP managers using SNMP version
2c or lower.
Trap Community Enter the Trap Community string, which is the password sent with each trap to
the SNMP manager.
The
Trap Community string is only used by SNMP managers using SNMP
version 2c or lower.
Trap Destination Use this section to configure where to send SNMP traps from the ONU.