ZyXEL Communications NWA-3166, User Manual

Page: 212 / 332

Chapter 19 Log Screens
NWA-3166 User’s Guide
212
19.4.2 Log Commands
Go to the command interpreter interface (refer to Appendix F on page 309 for a discussion
on how to access and use the commands).
19.4.3 Configuring What You Want the NWA to Log
Use the
sys logs load
command to load the log setting buffer that allows you to configure
which logs the NWA is to record.
Use
sys logs category
followed by a log category and a parameter to decide what to
record
Use the
sys logs save
command to store the settings in the NWA (you must do this in
order to record logs).
19.4.4 Displaying Logs
Use the
sys logs display
command to show all of the logs in the NWA’s log.
Use the
sys logs category display
command to show the log settings for all of the log
categories.
Use the
sys logs display [log category]
command to show the logs in an individual
NWA log category.
Use the
sys logs clear
command to erase all of the NWA’s logs.
19.4.5 Log Command Example
This example shows how to set the NWA to record the error logs and alerts and
then view the results.
Table 73 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
Use
0
to not record logs for that category,
1
to record only logs for that category,
2
to
record only alerts for that category, and
3
to record both logs and alerts for that
category.
ras> sys logs load
ras> sys logs category error 3
ras> sys logs save
ras> sys logs display access
#. time source destination notes
message
0 | 11/11/2002 15:10:12 | 172.22.3.80:137 | 172.22.255.255:137 | ACCESS
BLOCK