ZyXEL NBG-415N User’s Guide
49
Chapter 4 WAN
The following table describes the related fields in this screen.
4.2.5 WAN Connection: L2TP
If your ISP uses L2TP protocol for Internet access, select
L2TP
in the
WAN Mode
field.
Table 16
Basic: WAN: PPTP
LABEL
DESCRIPTION
MODES
WAN
Select
PPTP
if your ISP gives you Internet access account information (such as
the username and password).
PPTP WAN MODE
Address Mode
Select
Dynamic IP
If your ISP did not assign you a fixed IP address. This is the
default selection.
Select
Static IP
If your ISP assigned a fixed IP address. The set the following
fields.
PPTP IP Address
This field is applicable if you select
Static IP
in the
Address Mode
field.
Enter the IP address that your ISP gave you. This should be a static, public IP
address.
PPTP Subnet
Mask
This field is applicable if you select
Static IP
in the
Address Mode
field.
Enter the subnet mask for the IP address.
PPTP Gateway IP
Address
This field is applicable if you select
Static IP
in the
Address Mode
field.
Enter the IP address of the router through which this WAN connection will send
traffic (the default gateway).
PPTP Server IP
Address (may be
same as gateway)
Type the IP address of the PPTP server.
User Name
Type the user name given to you by your ISP. You can use alphanumeric and -
_@$./ characters, and it can be up to 31 characters long.
Password
Type the password associated with the user name above. Use up to 64 ASCII
characters except the [, ] and ?. This field can be blank.
Verify Password
Type your password again for confirmation.
Reconnect Mode
Specify how you want to re-establish an Internet connection after the idle timeout.
Select
Always On
when you want your connection up all the time. The ZyXEL
Device will try to bring up the connection automatically if it is disconnected.
Select
On Demand
when you don't want the connection up all the time and
specify an idle time-out in the
Maximum Idle Timeout
field.
Select
Manual
when you want to manually re-establish the connection if it is
disconnected.
Maximum Idle Time This value specifies the time in seconds that elapses before the ZyXEL Device
automatically disconnects from the PPPoE server.
Summary of Contents for NBG-415N
