ZyXEL Communications GS-2724, User Manual

Page: 277 / 348

Chapter 40 Configuration Mode Commands
GS-2724 User’s Guide
277
where
An example is shown next.
• Create a filtering rule called “filter1”.
• Drop packets coming from and going to MAC address 00:12:00:12:00:12 on VLAN.
40.8 Enabling Trunking
To create and enable a trunk, enter
trunk
followed by the ports which you want to group and
press [ENTER]
.
Syntax:
trunk <T1|T2|T3|T4|T5|T6>
trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
trunk <T1|T2|T3|T4|T5|T6> lacp
where
An example is shown next.
• Create trunk 1 on the Switch.
• Place ports 5-8 in trunk 1.
name <name>
= Names the filtering rule.
mac <mac-addr>
= Specifies the MAC address you want to filter.
vlan <vlan-id>
= Specifies which VLAN this rule applies to.
drop <src/dst/both>
= Selects the behavior of the rule.
• src - drop packets coming from the specified MAC
address
• dst- drop packets going to the specified MAC
address
• both - drop packets coming from or going to the
specified MAC address
sysname(config)# mac-filter name filter 1
sysname(config)# mac-filter name filter 1 mac 00:12:00:12:00:12 vlan 1 drop
both
<T1|T2|T3|T4|T5|T6>
= Enables the trunk.
<T1|T2|T3|T4|T5|T6>
interface <port-list>
= Places ports in the trunk.
<T1|T2|T3|T4|T5|T6> lacp
= Enables LACP in the trunk.