PG 18
ZYTRONIC PROJECTED CAPACITIVE ZXY100/110
®
TOUCH CONTROLLER & SENSOR
INTEGRATION MANUAL
ISSUE 1
ZYTRONIC
ATTACHING THE SENSOR
FLEXIBLE CABLES
The flexible cable bend radius at the sensor edge, and along the cable length, should be a
minimum of 2.5mm, as shown in Figure 15.
FIGURE 15
FLEXIBLE CABLE BENDING AT SENSOR EDGE
The flexible cables should be plugged into the controller PCB, as shown in Figure 16.
FIGURE 16
FLEXIBLE CABLES PLUGGED INTO THE CONTROLLER PCB
The gold contact side of the flexible cable should be visible, as depicted on the label shown
in Figure 17.
MINIMUM 2.5MM RADIUS
Summary of Contents for ZXY100
