Zypcom Z34-PC, User Manual

Page: 74 / 132

3-30
3
\Xn (XON/XOFF
pass-through)
If software flow control is enabled (\Q1), this command
defines whether the XON (11h) and XOFF (13h)
characters received from the DTE are sent to the remote
modem. If the modem port flow control is enabled (\G1)
in normal mode, this command specifies whether the
XON and XOFF characters received from the remote
modem are sent to the DTE. In both cases, flow control
operation is not affected.
C
OMMAND
D
ESCRIPTION
\X0* Processes flow control characters.
\X1 Processes flow control characters and
passes them through.
-Jn (V.42 Detect
Phase)
In V.42 modes (\N3, \N4), specifies whether the modem
detects V.42, MNP, or no error-correcting protocols from
the remote modem and changes to the appropriate
mode. Otherwise, only V.42 is attempted.
C
OMMAND
D
ESCRIPTION
-J0 Disables the V.42 detect phase.
-J1* Enables the V.42 detect phase.
"Hn (V.42bis
Control)
Specifies whether the data in the LAPM frames are
compressed using V.42 bis data compression.
Compression can be negotiated to operate in one
direction or both.
C
OMMAND
D
ESCRIPTION