HDME-804 Manual V1.0 1/16
7
DEVICE Programming and Setup:
Connecting to the GUI Interface:
Factory Default IP: 192.168.1.9
1.
Connect an Ethernet cable directly (
no Cross Over cable required
) to the Web Management Port on the rear panel
of the encoder or connect the Ethernet cable to an Ethernet switch. Connect an Ethernet Cable to your PC/Laptop.
2.
Modify your PC/Laptop IP address to 192.168.1.11.
3.
Enter ‘192.168.1.9’ into your web browser.
4.
Enter GUI and make required device changes.
5.
Save all changes as required, upload and reboot changes.
6.
Verify parameters then end web session.
Encoder Programming and Setup via GUI Interface
:
After connecting the device to the “Web Management” port located on the rear of the device and connecting to a PC /
Laptop.
Step 1:
Enter Device's IP address in web browser.
Overview Page of Encoder