HDME-804 Manual V1.0 1/16
9
Common Setup
Use the Common Setup Page to set the Output channel, Select VCN Mode, and Device Address.
Step 4: Local Save
Perform
a
Local Save
once all parameters are set.
Application Note:
When installing more than 1 device in a headend, the integrator must select a unique Device Address for each Encoder
being installed in the system.
If outputting directly into a HDTV, you must first attenuate the output (+45dBmV typical).
Notes on Changes:
Changes made to an individual setup tab may require the installer to perform a
Local Save
AND
Upload and Reboot
if
only making changes to one parameter of the encoder.
Example:
Installer is required to change only the output channel for the device (No other changes to the device are
required). Once the channel has been changed, the installer is required to perform
1) Local Save
AND
2) Upload and
Reboot.
