Zünd L-1200, Operating Manual

Page: 93 / 142

PN series frame version Controls and operation
Command description
4-45
110006,001,11-2009, jmu
4
4.5.5 Basic setting (5)
SERIAL LINK (51) This submenu contains commands for setting up and monitoring data transmission.
BAUD (511) Used to set the Baud rate between 600 and 38,400 Baud.
FORMAT (512) The following combinations of data, parity and stop bits can be set:
7 data bits, 1 stop bit, odd parity
7 data bits, 1 stop bit, even parity
8 data bits, 1 stop bit, none parity
8 data bits, 1 stop bit, odd parity
7 data bits, 1 stop bit, even parity
9 data bits, 1 stop bit, none parity
PROTOCOL (513) For selecting the following transmission protocols:
• Hardware handshake HW
• Software handshake (XOn/XOff protocol) SW
TERMINAL CHECK (514) All data received via the interface is shown on the display, but is not processed by
the machine.
SCI DIAGNOSTIC (515) If the data transmission is interrupted, the following settings can be used to call up
test functions for data analysis:
The standard setting is "1".
UNITS (52) You use this submenu to define the length unit for:
– Length entries, such as feed length, Z depth and height
– Display indications
– Internal calculations
UNITS (521) Select length unit:
METRIC (5211) – Using the arrow keys (left/right)
– By entering the command number using the numeric keypad
INCHES (5212) Confirm with the ENT key and save as a configuration parameter.
ON All interruptions to the serial interface are output.
1
Incorrect or incomplete HPGL commands and
parity errors are shown on the display and are
documented in an error message.
2 Incomplete HPGL commands are shown on the
display.