Zünd L-1200, Operating Manual

Page: 69 / 142

PN series frame version Controls and operation
Command description
4-21
110006,001,11-2009, jmu
4
The "Standard" settings for a "Marker" are as follows:
The "Standard" settings for a "Cutter" are as follows:
SET AND SAVE
Saving standard parameters:
It is advisable to save the standard configuration or the settings that are used most
frequently as configuration block 1.
Example:
Save configuration block 1:
The basic configuration can be saved as configuration block 1 using <ESC> 12522.
When the plotter is switched on, the standard parameters are loaded.
Save configuration block 2:
Set the parameters to suit the application.
Example:
Save configuration block 2 using <ESC> 12532.
Once all settings have been made correctly, it is possible to switch between block 1
and 2 using the "TOGGLE CONFIG" or "LOAD CONFIG x" function.
The configuration can also be changed using a software (HPGL) command.
MODE NO VACUUM (128)
ROLL OFF CORE (1291)
FIXING CLAMP B. (1293)
ROLL-UP CORE (1294)
MODE VAC / VAC + STOP (128)
ROLL OFF NONE OR CORE (1291)
FIXING VAC / VAC + CLAMP
B.
(1293)
ROLL-UP NONE OR CORE (1294)
MODE NO VAC (128 U) U = User parameter
(save using <ESC>
42)
ROLL OFF CORE (1291 C) *
FIXING VAC / CLAMP B. (1293 C) *
CORE ROLL-UP (1294 C) * C = Configuration
parameter (save using
<ESC> 46)
MODE VAC or VAC + STOP (128 U)
ROLL OFF NONE or CORE (1291 C)
VAC FIXING (1293 C)
ROLL-UP NONE or CORE (1294 C)