Zünd L-1200, Operating Manual

Page: 80 / 142

Controls and operation PN series frame version
Command description
4-32
110006,001,11-2009, jmu
4
As a final check, carry out a test cut with the functions 2431 and 2432 resp.
Corrections can be made for all tools separately (tools 1-4). When all tools are pro
-
perly set up, save the configuration parameters (46).
Important !
This procedure must be repeated every time a tool is changed.
ADJUST XY (241)
X CORRECTION (2411) Enter the corrective parameter for the X-direction here.
Y CORRECTION (2412) Enter the corrective parameter for the Y-direction here
TEST-CUT (2413) Performs a test cut.
ADJUST TANG (242) The tangential angle can be readjusted by up to +/- 10° from the default setting (the
knife is positioned at an angle to the cutting edge).
Important !
Changing the tangential angle may damage the tool!
TEST PATTERN (243)
POLYGON (2431) Cuts 2 octagons to check the corrective parameters.
If you place the two parts that have been cut on top of each other, the edges will show
four errors in the Y axis.
An error in the X-axis results in corners not being cleanly cut.
RECTANGLE (2432) Cuts two rectangles to check the corrective parameters.
LINK TO TOOL (244)
TOOL 1 (2441)
TOOL 2 (2442)
TOOL 3 (2443)
TOOL 4 (2444) Assign the correction option to the tool here.