Zünd L-1200, Operating Manual

Page: 90 / 142

Controls and operation PN series frame version
Command description
4-42
110006,001,11-2009, jmu
4
The park position can be cancelled using numerical key '3' only. When this is done,
the head moves to the last position from before the PARK command.
The park position:
– Is defined in service mode
– Is saved in the plotter Setup
– Can change depending on the tool head installed and the available options
PUMP ON/OFF (3931) You use this command to switch the vacuum pump/blower on/off.
In the park position, the command is executed by pressing numerical key 1 on the
operating unit.
VALVE ON/OFF (3932) The vacuum valve switches between intake and exhaust. The valve must be exhaus
-
ted for a material change during operation of the vacuum pump.
In the park position, the command is executed by pressing numerical key 2 on the
operating unit.
END PARKING (3933) The tool head leaves the park position and continues with the plot job or moves to
the reference point.
In the park position, the command is executed by pressing numerical key 3 on the
operating unit.
SELECT TOOL (394) The commands in this submenu enable the active tool to be changed quickly.
Conditions:
The commands are assigned to a specific function key on the operating unit using
the command SET USER KEY (45).
TOOL + (3941) This command increases the number of the active tool by 1 until the highest tool num
-
ber is reached.
TOOL - (3942) This command decreases the number of the active tool by 1 until the first tool is ac
-
tive.
4.5.4 User (4)
This submenu is a ZÜND-specific extension that enables users to manage up to 9
different user parameters.
A user parameter group contains settings and defaults for the following commands:
For "TZ" parameters, see also chapter "User Parameters".
LOAD (41) This command automatically loads a stored group and replaces the current user pa
-
rameter.
1 Vac pump is [on/off]
Vacuum is on
Exit Park
On/Off vacuum pump
2 Intake/exhaust by switching valve
3 Exit submenu and park position
CUT OFF PEN DELAY
SET USERSTRING POS UP
ACCEL POS DOWN
FUNCTION KEY KNIFE PRESSURE
SPEED XY-UP TOOL POSITION
SPEED XY-DOWN ZOOM
INTERFACE PARAMETER