Zoomlion RT35, Operator'S Manual

Page: 39 / 171

RT35 Rough Terrain Crane 05 - 1
5.1 OPERATING CONDITIONS
A. Always use the correct light diesel fuel and engine oil. Make your selection on the
lowest ambient temperature where you are to do the work. Refer to the table below for
more data on diesel and engine oil. Obey the Engine Manual if the data in this table is
incorrect.
Engine Emission Oil Brand Specification
According to guidelines
per US EPA Tier 3
Emission Standards
Sulfur content
＜
15 PPM,
according to US EPA2007
regulations
CH – 4 stage, API classification
According to guidelines
per EURO stage III A
Emission Standards.
Sulfur content < 15 PPM,
according to EN 590
regulations. CH – 4 stage, API classification
 The fuel sulfur content in the fuel must be less than 15 PPM to obey US EPA
Tier 3 Emission Standards.
 The fuel sulfur content must be less than 15 PPM to obey EURO stage III A
Emission Standards.
 Do not use fuel that is mixed with a lubricant or unqualified additives.
B. All mechanical components are in a break-in state during initial crane operation (less
than 100 operating hours). You must follow the below instructions during this time
period:
 The working load and working speed must not be too high.

The maximum lift capacity should not be larger than 80% of the rate one.
 Do not operate the crane at a speed that is more than the maximum limits.
C. Make sure that you do all of the work on level ground that is hard. The ground must
hold more than the load bearing capacity (permissible ground pressure
≥ 507.5 PSI
(3.5 MPa). Use material (such as wooden timbers) below the outrigger floats if the
work area is soft or not flat.
D. Before you operate the crane that is supported on outriggers, all wheels must not
touch the ground. Before "On tires lifts", make sure that you align the crane wheels to
the middle.
E. Do not operate the crane if the temperature at the job-site is more than -4° F to 104° F
(-20° C to +40° C).
F. If wind speed is greater than the permissible value of 45 ft/s (13.8 m/s), while the
crane is in operation, do the tasks that follow:
  Stop the work (safely lower the load).
Warning