Zoomlion RT35, Operator'S Manual

Page: 129 / 171

RT35 Rough Terrain Crane 07 - 37
7. 17 JIB OPERATION
A. The crane has a 2-section jib. Section 1 is a lattice structure and section 2 is a
box-shaped structure.
B. When the operation does not use the jib, it is installed on the right side of the boom. It
connects to boom by pins.
C. You can assemble the jib at an angle of 0°, 20° or 40° to the telescopic boom
according to working requirements.
You cannot use the jib when you lift a load if the outriggers are not in
the correct position.
D. Assemble the jib. Refer to Figures 07 – 34 to Figure 07 – 43.
Take out the auxiliary hook from the hook holder before assembling the jib.
Figure 07 – 34 Auxiliary Hook
Assembly of the jib below an angle of 0

:
(1) Extend the outriggers and make the crane level.
Figure 07 – 35 Bubble Level Indicator
(2) Retract the boom fully.
(3) Move the boom to the front of the crane and position it to -3°.
(4) Extend the intermediate bracket and remove the pin (1).
Warning