Zoom Sampletrak ST-224, Operation Manual

Page: 57 / 76

"Resampling" refers to returning the output of the ST-224 to the sampler section for repeated sampling in the
digital domain. This can be used to create a new sample based on multi-pad play or song playback by the
internal sequencer. The new sample can then again be assigned to a pad. Resampling is also possible while the
internal effects are active.
The [RECORD] LED flashes and the ST-224 goes into the sampling
standby condition.
The [RE-SAMPLE] LED lights up and the ST-224 is in the resampling
standby condition.
• To terminate resampling after a preset interval
Hold down the [PLAY/STOP] key, and use the [-] [+] keys to set the
auto sampling time ( ➔ p. 24 ).
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
EFFECT
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW-PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT 3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
MAX MIN MAX MIN
INPUT OUTPUT
PEAK
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOP REC
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
BANK
1
BANK 1– 3 keys + –
[–] [+] keys
[EFFECT SELECT]
switch
RECORD
To resample pad play, use the [BANK 1] - [BANK 3] keys to select the bank which
contains the desired pad. To resample a song, use the [-] [+] keys to select the song.
1
STEP
Press the [RECORD] key.
3
STEP
Select the desired sampling grade and the mono/stereo setting.
4
STEP
If desired, select the internal effects.
2
STEP
57
Using
the
Resampling
Function
Resampling Pad Play or Songs
Using the Resampling Function
RE-SAMPLE
Press the [RE-SAMPLE] key.
5
STEP
To terminate resampling automatically, perform the following steps, depending on the
desired mode.
6
STEP