Zoom Sampletrak ST-224, Operation Manual

Page: 56 / 76

The ST-224 incorporates a play list function which lets you assign songs 1 - 8 to pads 1 - 8 and play the songs
by hitting the pads. This section explains how to use this function.
Playing Songs With Pads (Play List Function)
56
Playing
Songs
With
Pads
(Play
List
Function)
The ST-224 goes into play list mode. The [PLAYLIST] LED lights up
and the [BANK 1] - [BANK 3] LEDs go out. Songs 1 - 8 are now
assigned to pads 1 - 8 and can be played with the pads.
The LED of the pad lights up and the song assigned to the pad is
played back in loop mode.
Only one song can be played at a time. If another pad is pressed
while a song is playing, the previous song stops and playback of the
new song starts.
The song continues to play also after the pad is released.
The [PLAYLIST] LED goes out and the unit reverts to normal play
mode.
Also during play list playback, the internal effects and the
[SOURCE] pad for input source playback can be used.
HINT HINT
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW-PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT 3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOP REC
BPM/VALUE
MEASURE SAMPLE/SONG BEAT
PLAYLIST
Pads 1 – 8
Pads 1 – 8
Record songs 1 - 8 to assign to the pads.
1
STEP
While the unit is in play mode, press the [PLAYLIST] key.
2
STEP
Press one of pads 1 - 8.
3
STEP
To switch songs, hit another pad.
4
STEP
LOOP/MARK
[LOOP/MARK] pad
To set song playback to the hold mode, press the [LOOP/MARK] pad.
5
STEP
PLAYLIST
To terminate the play list mode, press the [PLAYLIST] key.
6
STEP
Assigning Songs to Pads