Zoom Sampletrak ST-224, Operation Manual

Page: 52 / 76

The [SONG FUNCTION] LED flashes.
When the [SONG FUNCTION] key is pressed, the pads serve to
select the parameters printed at the bottom right. When a pad is
pressed, the [SONG FUNCTION] LED and the LED of the pad are
constantly lit, and the setting of the respective parameter appears on
the display. (For details on the song function parameters, see page
53 .)
The [SONG FUNCTION] LED goes out and the changed parameter is
accepted. To cancel the parameter change, press the [EXIT] key
instead of the [SONG FUNCTION] key.
52
Creating
Songs
The length of a song or the number of beats, the metronome sound volume, pre-count setting and other
song settings (song function parameters) can be changed, as follows.
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
EDIT 2
EXTREME EQ
RESONANCE
HIGH-PASS
LOW-PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT 3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
MEASURE SAMPLE/SONG BEAT
SONG
PAD
FUNCTION
SONG
PAD
FUNCTION
Pads 1 – 8
+ –
[–] [+] keys
+ –
EDIT 1
[EDIT 1]
wheel
[–] [+] keys
Press the [SONG FUNCTION] key.
2
STEP
In play mode, use the [-] [+] keys to select the song number (1 - 8).
1
STEP
Select the item to be set, using pads 1 - 8.
3
STEP
Use the [-] [+] keys or the [EDIT 1] wheel to change the setting.
4
STEP
Press the [SONG FUNCTION] key again.
5
STEP
Changing Song Settings
Parameter setting values
BPM/VALUE
MEASURE SAMPLE/SONG BEAT