Zoom Sampletrak ST-224, Operation Manual

Page: 11 / 76

BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
MAX MIN MAX MIN
INPUT OUTPUT
PEAK
INPUT
R L/MONO MIC/LINE
OUTPUT
R L/MONO PHONES
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
5
PRE COUNT
END POINT
TIME SIG
START POINT
7
CLICK VOLUME
REVERSE
COPY DELETE
EXIT
+ –
MEASURE SAMPLE/SONG BEAT
BPM/VALUE
BACKUP
SPECIAL LOAD SAVE INTERNAL/DATA CARD
Turn power on in the order ST-224
playback equipment. Adjust the
[OUTPUT] knob on the ST-224
and the volume control on the
playback equipment to obtain the
desired volume.
Hit any of the pads 1 - 8 to try out
the sound.
When you hit a pad, its LED lights up and
the preset sampling content is played. Pads
1 - 8 are preprogrammed with different
samples.
To switch pads 1 - 8 to a different
bank, press the [BANK 2] key.
The ST-224 incorporates three banks
(groups of settings for pads 1 - 8). In the
factory default condition, banks 1 and 2 are
preprogrammed with different samples.
[Preparations ]
• Connect the ST-224 to the playback equipment ( p. 8 ).
• The Quick Guide assumes that the ST-224 is in the
factory default condition. To return the ST-224 to the
factory default condition, hold down the [SAVE] key
while turning power to the unit on in step .
To repeat the sound of a pad, hit
the pad while holding the
[LOOP/MARK] pad down.
While the [LOOP/MARK] pad is held, the
sound of a pad is looped.
PHONES
t
OUTPUT L/MONO
OUTPUT R Playback equipment
Headphones
d
ZOOM CORPORATION
MADE IN JAPAN
MODEL
L/ MONO PHONES R DATA CARD MIDI IN DC9V
300mA
POWER
OUTPUT
L/ MONO LINE/MIC R
INPUT
11
Quick
Guide
Quick Guide (2) Playing the Preset Pads
The ST-224 allows assigning sampled sounds to pads and playing these manually (pad play). You can try out
the preset sounds that are assigned to the pads at the factory.