Q00110 Rev A 8/06
Page 106 of 225
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
3.
To bring up the setup MENU, “Press” the jog dial control (labeled “PUSH ENTER”).
4.
Use your finger to “Roll” the jog dial control until the desired setting for configuration is
shown in the display window.
5.
“Press” the jog dial control to select the offered setting for modification.
6.
“Roll” the jog dial control until the desired value is displayed in the window.
7.
“Press” the jog dial control to store the displayed value as the new setting.
8.
Repeat the above “Roll”/”Press” steps for configuring each of the remaining user settings into
the UP-897MD.
IMPORTANT
: To SAVE all of the newly configured settings, it is necessary to do the following
steps:
9.
“Roll” the jog dial until “SAVE” is displayed in the setup menu window.
10.
“Press” the jog dial control, and then “Roll” it to select which one of three possible user setup
types (1, 2 or 3) you wish to save.
11.
“Press” the jog dial to save the desired user settings type
12.
To manually exit out of the setup MENU, “Roll” the jog dial until “BACK” is displayed in the
setup menu window, and then “Press” the jog dial.
NOTE: The setup menu will exit, and automatically return to the normal “Ready” printer
state, when no new user actions are made on the jog dial for approximately 20
seconds.
Summary of Contents for Z.ONE
Page 1: ......
