background image

9650-000840-01 Rev. B

SurePower

TM

 ll Battery Pack Guide

1

Introduction

The 

SurePower

TM

 II Battery Pack

 is a rechargable, sealed lithium ion battery for use in 

compatible ZOLL

 

®

 defibrillator/monitors and chargers.

It is important that you read and understand the information in this manual. The proper use of 
the 

SurePower II Battery Pack 

is critical to the reliable operation of your ZOLL defibrillator/

monitor.

Conventions

This manual uses the following conventions:

Warning statements describe conditions or actions that can result in personal injury or 
death.

Caution

Caution statements describe conditions or actions that can result in damage to the 

SurePower II 

Battery Pack

.

Note:

Notes contain additional information on using and maintaining the 

SurePower II 

Battery Pack

.

The manual displays button and LED labels in 

bold

 face type.

Safety

The following sections provide important warnings, cautions, and notes regarding the ZOLL 

SurePower II Battery Pack

.

Warnings

Locate ZOLL defibrillator/monitor units where they cannot harm the patient or medical 
personnel if they fall -- accidental sliding or drop of the 

SurePower II Battery Pack

 may 

cause physical injury. Damaged batteries may expose users to a safety hazard. Should the 

SurePower II Battery Pack

 be dropped, inspect and test the unit prior to further use 

following the procedures described in the 

Maintenance

 section of this Guide. 

Avoid prolonged exposure of the 

SurePower II Battery Pack 

to direct sunlight to minimize 

heating and damage that may occur from exposure to ultraviolet light.

SurePower II Battery Packs

 have been tested against interference from radio frequency 

emissions typical of two-way radios used in emergency service/public safety activities. 
Refer to the appropriate ZOLL defibrillator/monitor operator’s guide to determine 
recommended operating distances from RF transmission equipment

Do not use 

SurePower II Battery Packs

 unless they have been visually inspected, tested, and 

recalibrated by appropriate personnel and you have been adequately trained in the proper 
use of these batteries. See the 

Maintenance 

section of this guide for more information.

Do not disassemble the 

SurePower II Battery Pack

.

Charge the 

SurePower II Battery Pack

 in a well-ventilated area.

You must perform periodic inspection, capacity testing, and functional testing of 
rechargable defibrillator batteries to ensure the availability of safe and reliable batteries. See 
the 

Maintenance 

section of this guide for more information.

Summary of Contents for SurePower II











Reviews: